Alexandr Ovcharenko Опубликовано 14 января, 2009 · Жалоба Чисто академический интерес. Есть каталист 3750G, у которого в конфиге: ! interface Port-channel1 switchport trunk encapsulation dot1q switchport trunk allowed vlan 1,2,4,5,7,8,10 switchport mode trunk switchport block multicast flowcontrol receive on end ! interface GigabitEthernet1/0/21 description DGS-3100 Trunk1 switchport trunk encapsulation dot1q switchport trunk allowed vlan 1,2,4,5,7,8,10 switchport mode trunk switchport block multicast ip access-group 151 in flowcontrol receive on no cdp enable channel-group 1 mode active end ! ! и еще 3 порта-мембера с абсолютно одинаковыми настройками ! На другом конце Ether-channel подключен D-Link DGS-3100-24TG, у которого порты-мемберы имеют включенный flow-control. Смотрим на каталисте состояние канала: Core3#sh int port-ch 1 Port-channel1 is up, line protocol is up (connected) Hardware is EtherChannel, address is 0021.a16f.4798 (bia 0021.a16f.4798) MTU 1500 bytes, BW 4000000 Kbit, DLY 10 usec, reliability 255/255, txload 4/255, rxload 2/255 Encapsulation ARPA, loopback not set Full-duplex, 1000Mb/s, link type is auto, media type is unknown input flow-control is off, output flow-control is unsupported Members in this channel: Gi1/0/21 Gi1/0/22 Gi1/0/23 Gi1/0/24 ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:07, output 00:00:00, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/max) 5 minute input rate 44765000 bits/sec, 8676 packets/sec 5 minute output rate 67984000 bits/sec, 9764 packets/sec 1028758349 packets input, 911529861569 bytes, 0 no buffer Received 1296792 broadcasts (0 multicasts) 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 106996 multicast, 0 pause input 0 input packets with dribble condition detected 1077308766 packets output, 934911433934 bytes, 0 underruns 0 output errors, 0 collisions, 1 interface resets 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier, 0 PAUSE output 0 output buffer failures, 0 output buffers swapped out Вопрос - и чего не хватает для того, чтобы flow-control включился? Вставить ник Цитата Ответить с цитированием Поделиться сообщением Ссылка на сообщение Поделиться на других сайтах More sharing options...