[FenX]

Hi All!

 

Помогите с простой агрегацией портов

 

Centos 6.5 настраивал согласно http://www.alsigned.ru/?p=2896

 

когда создаю на коммутаторе port-group 1 и добавляю в нее интерфейсы пинг до centos пропадает

 

# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009)

Bonding Mode: IEEE 802.3ad Dynamic link aggregation
Transmit Hash Policy: layer2+3 (2)
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0

802.3ad info
LACP rate: slow
Aggregator selection policy (ad_select): stable
Active Aggregator Info:
       Aggregator ID: 5
       Number of ports: 1
       Actor Key: 17
       Partner Key: 1
       Partner Mac Address: 00:00:00:00:00:00

Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 3
Permanent HW addr: a4:ba:db:11:18:7f
Aggregator ID: 5
Slave queue ID: 0

Slave Interface: eth1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 3
Permanent HW addr: a4:ba:db:11:18:81
Aggregator ID: 6
Slave queue ID: 0

Slave Interface: eth2
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 3
Permanent HW addr: a4:ba:db:11:18:83
Aggregator ID: 7
Slave queue ID: 0

Slave Interface: eth3
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 3
Permanent HW addr: a4:ba:db:11:18:85
Aggregator ID: 8
Slave queue ID: 0

 

мак партнерского устройства тоже не обновляется

Изменено 19 октября, 2014 пользователем FenX