Помогите с настройкой SPA-1X10GE-WL-V2 на ASR102

All Activity

Reply to this topic

leveler

Posted June 25, 2013 · Report post

День добрый!

Есть модуль SPA-1X10GE-WL-V2 в ASR1002.

sh ver
Cisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVENTERPRISE-M), Version 15.2(4)S2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Tue 11-Dec-12 18:17 by mcpre

IOS XE Version: 03.07.02.S

Cisco IOS-XE software, Copyright (c) 2005-2012 by cisco Systems, Inc.
All rights reserved. Certain components of Cisco IOS-XE software are
licensed under the GNU General Public License ("GPL") Version 2.0. The
software code licensed under GPL Version 2.0 is free software that comes
with ABSOLUTELY NO WARRANTY. You can redistribute and/or modify such
GPL code under the terms of GPL Version 2.0. For more details, see the
documentation or "License Notice" file accompanying the IOS-XE software,
or the applicable URL provided on the flyer accompanying the IOS-XE
software.

ROM: IOS-XE ROMMON

ASR1002 uptime is 20 weeks, 4 days, 13 hours, 17 minutes
Uptime for this control processor is 20 weeks, 4 days, 13 hours, 19 minutes
System returned to ROM by reload at 06:00:00 NOVST Fri Feb 1 2013
System restarted at 06:03:56 NOVST Fri Feb 1 2013
System image file is "bootflash:asr1000rp1-adventerprise.03.07.02.S.152-4.S2.bin"
Last reload reason: Critical software exception, check bootflash:crashinfo_RP_00_00_20120208-171700-NOVST

cisco ASR1002 (2RU) processor with 1694460K/6147K bytes of memory.
Processor board ID XXXXXXXXXXX
9 Gigabit Ethernet interfaces
1 Ten Gigabit Ethernet interface
32768K bytes of non-volatile configuration memory.
4194304K bytes of physical memory.
7798783K bytes of eUSB flash at bootflash:.

Configuration register is 0x2102

sh platform
Chassis type: ASR1002

Slot      Type                State                 Insert time (ago)
--------- ------------------- --------------------- -----------------
0         ASR1002-SIP10       ok                    20w4d
0/0      4XGE-BUILT-IN       ok                    20w4d
0/1      SPA-5X1GE-V2        ok                    20w4d
0/2      SPA-1X10GE-WL-V2    ok                    4w5d
R0        ASR1002-RP1         ok, active            20w4d
F0        ASR1000-ESP5        ok, active            20w4d
P0        ASR1002-PWR-AC      ok                    20w4d
P1        ASR1002-PWR-AC      ok                    20w4d

Slot      CPLD Version        Firmware Version
--------- ------------------- ---------------------------------------
0         07120202            12.2(33r)XNC
R0        08011017            12.2(33r)XNC
F0        07091401            12.2(33r)XNC

Цыска подключена к Длинку. Всё в апе:

ASR1002#sh int te0/2/0
TenGigabitEthernet0/2/0 is up, line protocol is up
 Hardware is SPA-1X10GE-WL-V2, address is c471.fe9b.1520 (bia c471.fe9b.1520)
 MTU 9216 bytes, BW 10000000 Kbit/sec, DLY 10 usec,
    reliability 255/255, txload 1/255, rxload 1/255
 Encapsulation 802.1Q Virtual LAN, Vlan ID  1., loopback not set
 Keepalive not supported
 Full Duplex, 10000Mbps, link type is force-up, media type is 10GBase-LR
 output flow-control is on, input flow-control is on
 ARP type: ARPA, ARP Timeout 04:00:00
 Last input never, output 00:03:02, output hang never
 Last clearing of "show interface" counters never
 Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 0
 Queueing strategy: fifo
 Output queue: 0/40 (size/max)
 5 minute input rate 21000 bits/sec, 32 packets/sec
 5 minute output rate 0 bits/sec, 0 packets/sec
    2014491509 packets input, 2558729516632 bytes, 0 no buffer
    Received 16919382 broadcasts (0 IP multicasts)
    0 runts, 0 giants, 0 throttles
    1 input errors, 1 CRC, 0 frame, 0 overrun, 0 ignored
    0 watchdog, 1919054791 multicast, 0 pause input
    0 packets output, 0 bytes, 0 underruns
    0 output errors, 0 collisions, 23 interface resets
    0 unknown protocol drops
    0 babbles, 0 late collision, 0 deferred
    0 lost carrier, 0 no carrier, 0 pause output
    0 output buffer failures, 0 output buffers swapped out

Плата в режиме LAN:

ASR1002#sh controllers wanphy 0/2/0
TenGigabitEthernet0/2/0
Mode of Operation: LAN Mode

Вот конфиг интерфейсов:

ASR1002#sh ru int te0/2/0
Building configuration...

Current configuration : 66 bytes
!
interface TenGigabitEthernet0/2/0
mtu 9216
no ip address
end

ASR1002#sh ru int te0/2/0.910
Building configuration...

Current configuration : 177 bytes
!
interface TenGigabitEthernet0/2/0.910
description Test Interface for Vlan910 | 2013-06-25 | Taras Kotov
encapsulation dot1Q 910
ip address 10.255.11.2 255.255.255.252
end

Но пакетики даже до 10.255.11.1 не ходят. Если внимательно приглядеться на вывод команды show int te0/2/0, то можно увидеть, что исходящих пакетов нет вообще.

Подскажите пожалуйста, куда копать? В чём может быть трабла?

Share this post

Link to post

Share on other sites

zstas

Posted June 26, 2013 · Report post

sh int te0/2/0.910

Share this post

Link to post

Share on other sites

leveler

Posted June 26, 2013 · Report post

ASR1002#sh int te0/2/0.910
TenGigabitEthernet0/2/0.910 is up, line protocol is up
 Hardware is SPA-1X10GE-WL-V2, address is c471.fe9b.1520 (bia c471.fe9b.1520)
 Description: Test Interface for Vlan910 | 2013-06-25 | Taras Kotov
 Internet address is 10.255.11.2/30
 MTU 9216 bytes, BW 10000000 Kbit/sec, DLY 10 usec,
    reliability 255/255, txload 1/255, rxload 1/255
 Encapsulation 802.1Q Virtual LAN, Vlan ID  910.
 ARP type: ARPA, ARP Timeout 04:00:00
 Keepalive not supported
 Last clearing of "show interface" counters never

Share this post

Link to post

Share on other sites

NikAlexAn

Posted June 26, 2013 · Report post

А с asr 11.2 пингуется?

Share this post

Link to post

Share on other sites

leveler

Posted June 26, 2013 · Report post

Да:

ASR1002#ping 10.255.11.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.255.11.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms

Так же 10.255.11.2 пингуется с других устройств в сети (ICMP-пакеты на ASR попадают через другой интерфейс).

Share this post

Link to post

Share on other sites

zstas

Posted June 26, 2013 · Report post

Posted July 12, 2013 · Report post

Up!

Пробовал другие слоты. Пробовал без VLAN (IP-адрес на интерфейсе без каких-либо сабинтерфейсов). Пробовал перезагружать железку.

Шины пинал, зеркала протирал, дверью хлопал...

Хз, что делать дальше. (

Share this post

Link to post

Share on other sites

Vadic

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

× Pasted as rich text. Paste as plain text instead

Only 75 emoji are allowed.

× Your link has been automatically embedded. Display as a link instead

× Your previous content has been restored. Clear editor

× You cannot paste images directly. Upload or insert images from URL.

Insert image from URL

Followers 0

Go to topic listing Активное оборудование Ethernet, IP, MPLS, SDN/NFV...

Sign In

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Share this post

Link to post

Share on other sites

Join the conversation