irlive WL-5460AP. воостановление

[drema7777]

Пивет. Принесли убитую WL-5460AP. До меня шили ее, но в момент прошивки что-то не срослось.что заливали до меня не знаю.пробывал залить recovery.bin http://approsoftware.com/download/rtl8186/recovery/ фтп-начал шить:нажал ресет,включил 5 сек и отпустил, ентер в командной строке - процесс пошел:начали мигать лампочки(две красных). но в чем беда лампочки мигают уже 12 часов и ничего не происходит. через веб не заходит, но есть пинг 192.168.1.6, 192.168.100.252. есть возможность повторить процесс заново. точку хочу оставить для себя из-за шейпера.спасибо

[drema7777]

HyperTerminal:

 

UART1 output test ok

Uart init

mfid=000000c2 devid=00002249

Found 1 x 2M flash memory

 

---RealTek(RTL8186)at 2005.05.06-13:43+0800 version 1.3b [16bit](180MHz)

no sys signature at 00010000!

sys checksum error at 00020000!

Jump to image start=0x80800000...

 

UART1 output test ok

Uart init

mfid=000000c2 devid=00002249

Found 1 x 2M flash memory

 

---RealTek(RTL8186)at 2005.05.06-13:43+0800 version 1.3b [16bit](180MHz)

no sys signature at 00010000!

sys checksum error at 00020000!

Jump to image start=0x80800000...

display on

entering boot loader, turning on display

decompressing kernel:

UNCOMPRESS_OUT: 80000000 FREEMEM_START: 00000000 FREEMEM_END: 81000000

UNCOMPRESS_OUT: 80000000 FREEMEM_START: 80908d94 FREEMEM_END: 81000000

Uncompressing Linux... done, booting the kernel.

done decompressing kernel.

jump kernel=80000000!

early printk enabled

Determined physical RAM map:

memory: 01000000 @ 00000000 (usable)

Initial ramdisk at: 0x801ea000 (4710400 bytes)

On node 0 totalpages: 4096

zone(0): 4096 pages.

zone(1): 0 pages.

zone(2): 0 pages.

Kernel command line: root=/dev/ram console=0 ramdisk_start=0 single

Calibrating delay loop... 179.40 BogoMIPS

Memory: 9372k/16384k available (1749k kernel code, 7012k reserved, 4740k data, 5

6k init, 0k highmem)

Dentry-cache hash table entries: 2048 (order: 2, 16384 bytes)

Inode-cache hash table entries: 1024 (order: 1, 8192 bytes)

Mount-cache hash table entries: 512 (order: 0, 4096 bytes)

Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)

Page-cache hash table entries: 4096 (order: 2, 16384 bytes)

check_wait... unavailable.

POSIX conformance testing by UNIFIX

Linux NET4.0 for Linux 2.4

Based upon Swansea University Computer Society NET3.039

Initializing RT netlink socket

Starting kswapd

Serial driver version 6.02 (2003-03-12) with no serial options enabled

ttyS00 at 0x00c3 (irq = 3) is a rtl_uart1

state->flags=00000000

Realtek GPIO Driver for Flash Reload Default

RTL8186LED: Led driver registered ©wwarczak@online.pl

led0: Initialized.

led1: Initialized.

led2: Initialized.

led3: Initialized.

block: 64 slots per queue, batch=16

RAMDISK driver initialized: 16 RAM disks of 4600K size 1024 blocksize

PPP generic driver version 2.4.1

PPP Deflate Compression module registered

PPP BSD Compression module registered

MPPE/MPPC encryption/compression module registered

RealTek E-Flash System Driver. © 2002 RealTek Corp.

Found 1 x 2M Byte MXIC MX29LV160CB at 0xbe000000

Offset: 0x0, erasesize: 0x4000, numblocks: 1

Offset: 0x4000, erasesize: 0x2000, numblocks: 2

Offset: 0x8000, erasesize: 0x8000, numblocks: 1

Offset: 0x10000, erasesize: 0x10000, numblocks: 31

NVRAM: 00006000 00002000 on "DiskOnChip Millennium"

RTL8185 driver version 1.11 (2006-07-18)

rtl8186_init: Loading new ethernet driver!!

8186NIC Ethernet driver v0.0.4 (Sep 23, 2005)

eth0: RTL8186-NIC at 0xbd200000, 00:01:02:03:04:05, IRQ 4

eth1: RTL8186-NIC at 0xbd300000, 04:05:06:07:08:09, IRQ 5

fast_nat v1.3b-abc

NET4: Linux TCP/IP 1.0 for NET4.0

IP Protocols: ICMP, UDP, TCP

IP: routing cache hash table of 512 buckets, 4Kbytes

TCP: Hash tables configured (established 1024 bind 2048)

ip_conntrack version 2.1 (128 buckets, 1024 max) - 312 bytes per conntrack

PPTP netfilter connection tracking: registered

PPTP netfilter NAT helper: registered

ip_tables: © 2000-2002 Netfilter core team

NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.

NET4: Ethernet Bridge 008 for NET4.0

NET4: Bridge Netfilter support ©wwarczak@online.pl

NET4: Bridge Netfilter proc handler installed

RAMDISK: ext2 filesystem found at block 0

RAMDISK: Loading 4600 blocks [1 disk] into ram disk... done.

Freeing initrd memory: 4600k freed

VFS: Mounted root (ext2 filesystem).

Freeing unused kernel memory: 56k freed

mount /proc file system ok!

starting /bin/boot.sh!

Algorithmics/MIPS FPU Emulator v1.5

RTL8181/8186 SOC recovery software written by wwarczak@online.pl

Tech support http://approsoftware.com

Starting init

RELOAD INIT: start Sat Jan 1 01:00:02 CET 2000

INIT: Reading hardware configuration

INIT: Reading system configuration

BASIC: Setting telnet/SSH password

BASIC: Setting wlan0 hw ether: 56AAA55A7DE8

BASIC: Setting eth0 hw ether: 56AAA55A7DE8

BASIC: Setting eth1 hw ether: 56AAA55A7DE8

BASIC: Setting WDS hw ether: 56AAA55A7DE8

WLAN0: Setting wlan parameters

WLAN0: AP Mode SSID: recovery Channel: 7

WLAN0: Default Tx Power 63mW

WLAN0: No encryptiom method enabled

WLAN0: WPA AES WDS encryption method enabled

WLAN0: Loading user editable extended settings

TCPIP: configuring WLAN interface

TCPIP: Mode bridge: (wlan0 + WDS), eth0, eth1 bridged as br0

TCPIP: br0 IP: 192.168.100.252 Mask: 255.255.255.0

TCPIP: br0 IP: 192.168.0.6 Mask: 255.255.255.0

TCPIP: br0 IP: 192.168.1.6 Mask: 255.255.255.0

TCPIP: br0 IP: 192.168.3.6 Mask: 255.255.255.0

TCPIP: Default gateway: 192.168.100.254

MISC: Configuring nameserver: 62.146.126.67, 212.87.0.37

MISC: Dropbear keys exists

DHCP: Enabling DHCPD server on br0 IP: 192.168.100.252 SUB: 255.255.255.0

udhcpd (v0.9.9-pre) started

Jan 1 01:00:10 udhcpd[209]: udhcpd (v0.9.9-pre) started

max_leases value (254) not sane, setting to 100 instead

Jan 1 01:00:10 udhcpd[209]: max_leases value (254) not sane, setting to 100 ins

tead

RELOAD DONE: end Sat Jan 1 01:00:10 CET 2000

 

Linux recovery-recovery ~ #