Перейти к содержимому
Калькуляторы

BGP на 7206 BGP neigbor AS number

Хочу поднять BGP на циско 7206.

Номер АС провайдера 6-ти значная. Например пусть будет 195654

Когда я добавляю neighbor x.x.x.x remote-as 195654, рутер ругаеться что команда не правильная.Если убераю одну цифру и оставляю 5-ти значный номер АС , то команда проходит. Проблема именно в добавлении 6-ти значного номера. Если я ставлю вопрос , прежде чем написать номер АС , входят следующие варианты.

<1-65535> AS of remote neighbor

<1.0-XX.YY> 4 octets AS of remote neighbor

 

Нижний вариант меня заинтересовал, может ответ где то в нем ? Если не трудно подскажите. Версия прошивки рутера:

 

 

 

Cisco IOS Software, 7200 Software (C7200P-ADVENTERPRISEK9-M), Version 12.4(24)T, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright © 1986-2009 by Cisco Systems, Inc.

Compiled Thu 26-Feb-09 01:44 by prod_rel_team

 

ROM: System Bootstrap, Version 12.4(12.2r)T, RELEASE SOFTWARE (fc1)

BOOTLDR: Cisco IOS Software, 7200 Software (C7200P-KBOOT-M), Version 12.4(15)T1, RELEASE SOFTWARE (fc2)

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

 

 

я не нашел нужный мне ответ там. Я все таки думаю что моя циска потдерживает 6-ти значный номер АС. 6-ти значный номер АС равняеться 32 битам. 32 бита это 4 октета по 8 бит в каждой. <1.0-XX.YY> 4 octets AS of remote neighbor - это как раз и есть потдержка как я понимаю. Я просто незнаю как правильно записать и продолжить команду

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

BGP Support for 4-Byte ASN

 

12.0(32)S12

12.0(32)SY8

12.0(33)S3

12.2(33)SRE

12.2(33)XNE

12.2(33)SXI1,

12.4(24)T

15.0(1)S

Cisco IOS XE 3.1.0SG

 

The BGP Support for 4-Byte ASN feature introduced support for 4-byte autonomous system numbers. Because of increased demand for autonomous system numbers, in January 2009 the IANA will start to allocate 4-byte autonomous system numbers in the range from 65536 to 4294967295.

 

In Cisco IOS Release 12.0(32)SY8, 12.0(33)S3, 12.2(33)SRE, 12.2(33)XNE, 12.2(33)SXI1, and later releases, the Cisco implementation of 4-byte autonomous system numbers uses asplain as the default regular expression match and output display format for autonomous system numbers, but you can configure 4-byte autonomous system numbers in both the asplain format and the asdot format as described in RFC 5396. To change the default regular expression match and output display of 4-byte autonomous system numbers to asdot format, use the bgp asnotation dot command.

 

In Cisco IOS Release 12.0(32)S12, and 12.4(24)T, the Cisco implementation of 4-byte autonomous system numbers uses asdot as the only configuration format, regular expression match, and output display, with no asplain support.

 

The following sections provide information about this feature:

 

blank.gifBGP Autonomous System Number Formats

 

blank.gifConfiguring a BGP Routing Process and Peers Using 4-Byte Autonomous System Numbers

 

blank.gifModifying the Default Output and Regular Expression Match Format for 4-Byte Autonomous System Numbers

 

blank.gifExamples: Configuring a BGP Routing Process and Peers Using 4-Byte Autonomous System Numbers

 

blank.gifExamples: Configuring a VRF and Setting an Extended Community Using a BGP 4-Byte Autonomous System Number

 

The following commands were introduced or modified by this feature: bgp asnotation dot, bgp confederation identifier, bgp confederation peers, all clear ip bgp commands that configure an autonomous system number, ip as-path access-list, ip extcommunity-list, match source-protocol, neighbor local-as, neighbor remote-as, neighbor soo, redistribute (IP), router bgp, route-target, set as-path, set extcommunity, set origin, soo, all show ip bgp commands that display an autonomous system number, and show ip extcommunity-list.

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

Спасибо большое, ваши ссылки мне помогли. Ответ таков. Нужно перевести 6-ти значный номер АС в форму с точкой. Поможет этот калькулятор http://labs.spritelink.net/ascalc. После переобразования его в вид с точкой, добавляем <1.0-XX.YY> 4 octets AS of remote neighbor. Утром попробую, посмотрю что получилось.

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

Кому интересно можно считать и в ручную.

делим номер вашего 6-ти значного Ас ( 32 - бит ) на 65536 , полученное целое число добавляем до точки, остаток после точки.

Например. 196925:65536=3

3*65536= 196608

196925-196608=317

 

получаем 3.317

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Гость
Ответить в тему...

×   Вставлено в виде отформатированного текста.   Вставить в виде обычного текста

  Разрешено не более 75 смайлов.

×   Ваша ссылка была автоматически встроена.   Отобразить как ссылку

×   Ваш предыдущий контент был восстановлен.   Очистить редактор

×   Вы не можете вставить изображения напрямую. Загрузите или вставьте изображения по ссылке.