H323SignalPDU::read - atiDecode Err() Q931 PDU UUIE Decode Error

[qqqoid]

Есть два адпака, AP1100F и AP190. Первый в офисе, второй на очень удаленной площадке.

Вопрос заключается в следующем - почему с AP1100F на AP190 звонок проходит идеально, а обратно 99 из 100

идет обрыв

1048 <H245> : Control channel closed

H323SignalPDU::read - atiDecode Err()

Q931 PDU UUIE Decode Error

 

 

Версии:

 

AP-1100F:

 

VoiceFinder Gateway Series (AP1100F)

Serial Number: AP1100F-046460

32BIT RISC Processor With 50MHz Clock

32 Mbytes System Memory.

512 Kbytes System Boot Flash Memory

4 Mbytes System Flash Memory

Real-Time Clock Device with EEPROM

 

1 RS232 Serial Console Interface

1 Ethernet/IEEE 802.3 Interface (100BaseTX)

1 Ethernet/IEEE 802.3 Interface (10BaseT)

 

AP1100F System software Revision 8.23K

Released at Tue Apr 24 16:41:54 2007

Program is 2967632 bytes, checksum is 0x1782915d

 

AP-190:

 

VoiceFinder Gateway Series (AP190)

Serial Number: AP190-03d326

32BIT RISC Processor With 133MHz Clock

16 Mbytes System Memory.

512 Kbytes System Boot Flash Memory

2 Mbytes System Flash Memory

 

1 RS232 Serial Console Interface

2 Ethernet/IEEE 802.3 Interface (100BaseTX)

 

AP190 System software Revision 8.238

Released at Wed Feb 1 21:42:00 2006

Program is 1572240 bytes, checksum is 0xc4c2146

 

Конфиги:

 

AP-1100F:

 

!

interface ether0.0

ip address XXX.XXX.XXX.XXX ZZZ.ZZZ.ZZZ.ZZZ

!

voice service voip

fax protocol t38 redundancy 0

fax rate 9600

h323 call start fast

h323 call tunnel enable

!

!

! Voice port configuration.

!

! FXO

voice-port 0/0

connection plar 357

description Chert-i-Gde#357

no caller-id enable

!

! Pots peer configuration.

!

dial-peer voice 10 pots

destination-pattern 9357

port 0/0

!

!

!

! Voip peer configuration.

!

dial-peer voice 100 voip

destination-pattern 357

session target YYY.YYY.YYY.YYY

dtmf-relay h245-alphanumeric

vad

!

gatekeeper

!

!

! Gateway configuration.

!

gateway

h323-id voip.XXX.XXX.XXX.XXX

no ignore-msg-from-other-gk

!

!

! SIP UA configuration.

!

sip-ua

!

!

! MGCP configuration.

!

mgcp

codec g711ulaw

vad

!

 

AP-190:

 

!

interface ether0.0

ip address YYY.YYY.YYY.YYY ZZZ.ZZZ.ZZZ.ZZZ

qos-control 200 100

!

! VoIP configuration.

!

!

! Voice service voip configuration.

!

voice service voip

fax protocol t38 redundancy 0

fax rate 9600

h323 call start fast

h323 call tunnel enable

!

!

! Voice port configuration.

!

! FXS

voice-port 0/0

connection plar 9357

!

!

!

!

! Pots peer configuration.

!

dial-peer voice 10 pots

destination-pattern 357

port 0/0

!

!

!

! Voip peer configuration.

!

dial-peer voice 100 voip

destination-pattern 9357

session target XXX.XXX.XXX.XXX

dtmf-relay h245-alphanumeric

!

!

!

!

!

!

! Gateway configuration.

!

gateway

h323-id voip.YYY.YYY.YYY.YYY

!

!

mgcp

codec g711ulaw

vad

 

 

 

Дебаг:

 

AP-1100F:

 

200 <Call> : ****************** Call Created status(InitiatedByNet) *******************

201 <NetCon> : Found inbound voip peer by dest-pattern id(100)

202 <H323> : local capabilities.

number of capabilities = 4

1 : g711alaw-64k

2 : T.38

3 : UserInput/basicString

4 : UserInput/hookflash

203 <H225> : Remote Endpoint (AddPac VoIP,8.23,97,0,22)

204 <Q931> : Received SETUP from (YYY.YYY.YYY.YYY) : FastStart(0) Tunneling(0)

205 <Call> : From Net - calledParty(9357) callingParty(357)

206 <Call> : MatchedPerfect

207 <Call> : MatchAllProcess After Sorted <0> id(10) dest(9357) prefer(0) selected(52)

208 <Call> : Initiate callee with dial-peer(9357) status(CalleeDeterminedAll) id(3d313347-4d23-b9a2-8045-0002a403d326)

209 <CEP> : InitiateOutCall : calledNum(), callingNum(357), callerPort(ffffffff) type(FXO)

210 <CEP> : Outbound call to CEP callId(3d313347-4d23-b9a2-8045-0002a403d326) callNum(245)

211 <Q931> : Send CALL PROCEEDING

212 <Q931> : build PROGRESS (with h245 address)

213 <Q931> : Send ALERTING/PROGRESS

214 <Call> : Connected from(0)

215 <Q931> : Send CONNECT

216 <Q931> : startH245(forced with Facility)

217 <Q931> : Send FACILITY

218 <H245> : Send TCS request.

219 <H245> : Send MSD request.

220 <H245> : Control channel closed

221 <Q931> : Received RELEASE COMPLETE

222 <Call> : Terminated from(ffffffff) this(Remote:Unknown) before(NULL) forced(0)

223 <CEP> : DisconnectCall at Busy

224 <CEP> : StopSignal

225 <CEP> : Disconnect (0)

226 <NetEP> : Call FROM <voip> terminated reason(Remote:Unknown)

227 <CEP> : Disconnected(16) at Disconnecting

 

AP-190:

 

1026 <CEP> : Call Received

1027 <CEP> : Call Initiated : calledNumber() crv(0) total(0)

1028 <Call> : ****************** Call Created status(InitiatedByFXS) *******************

1029 <CEP> : Calling number(357)

1030 <CEP> : Call id(3d313347-4d23-b9a2-8045-02a43d326) callNum(46)

1031 <Call> : MatchAllProcess After Sorted <0> id(100) dest(9357) prefer(0) selected(34)

1032 <Call> : Initiate callee with dial-peer(9357) status(CalleeDeterminedAll) id(3d313347-4d23-b9a2-8045-02a43d326)

1033 <NetEP> : InitiateOutCall: calledNum(9357) callingNum(357) target(XXX.XXX.XXX.XXX)

1034 <NetEP> : DoCall: calledAddr(9357@XXX.XXX.XXX.XXX) callingAddr(357)

1035 <H323> : local capabilities.

number of capabilities = 4

1 : g729-8k

2 : T.38

3 : UserInput/basicString

4 : UserInput/hookflash

1036 <H225> : Try signalling TCP connect (XXX.XXX.XXX.XXX:1720)

1037 <H225> : Signalling TCP connect success (46)

1038 <Q931> : Send SETUP

1039 <Q931> : Received CALL PROCEEDING

1040 <Q931> : Received CALL PROCEEDING

1041 <Q931> : Received PROGRESS

1042 <Q931> : Received Progress Indicator : desc(8), coding(0), location(0)

1043 <H245> : Send TCS request.

1044 <H245> : Send MSD request.

1045 <Call> : Progress from(ffffffff)

1046 <Q931> : Received CONNECT

1047 <H225> : Remote Endpoint (AddPac VoIP,8.23,97,0,22)

1048 <H245> : Control channel closed

H323SignalPDU::read - atiDecode Err()

Q931 PDU UUIE Decode Error

1049 <Q931> : Received FACILITY

1050 <Q931> : Received RELEASE COMPLETE

1051 <Call> : Terminated from(ffffffff) this(Remote:Unknown) before(NULL) forced(0)

1052 <CEP> : DisconnectCall at Busy

1053 <CEP> : StopSignal

1054 <CEP> : Disconnect (0)

1055 <NetEP> : Call TO <voip> terminated reason(Remote:Unknown)

1056 <CEP> : Disconnected(16) at Disconnecting

[Mikler]

Я конечно не спец в Адпаках и эксплуатацией не занимаюсь...

Но поверхностно вижу что в Q931 в одной коробке и в другой разные тоесть гдето есть лишнии биты в сообщениях, илинет того что надо. А прошивку подновить не пробовали ?

[qqqoid]

жду ответа от продавцов, у меня нет свежее

[ram_scan]

Последний раз когда народ с подобным сталкивался дело было в некорректно йстановленой дате-времени на одном из девайсов.

[facility]

Мне интересно как у вас AddPac'и собираются догадаться о том какой кодек использовать?

Edited November 12, 2007 by facility

[ram_scan]

Если явно не указано иного, то используются при старте все доступные. Если это к вопросу о том что voice-class codec не указано нигде.