Перейти к содержимому
Калькуляторы

DMM-1400MX-40 firmware

Hello.
Can anyone share a link with firmware for PBI DMM-1400MX-40 Remux module?
Any version newer than 14MX002A would be good.
Having stability issues with this version.

Thank you!

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

Stability issues. When muxing TSs from ASI inputs, it blocks very often.

If I remove cables from ASI inputs, in HDMS it still shows bitrate on inputs.

Restart the unit, with no ASI input cables connected, and it shows bitrate...

I have multiple 1400MX, only one of them have this issue. And it's the only one with this firmware version, 14MX002A.

All the others have newer firmwares.

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

The working ones have:

Main version 14MX002A
FPGA Version 57.08.05
MCU Version 00.00.29
Hardware Version 00.03


The one with stability issues have:
Main version 14MX002A
FPGA Version 47.ef.ff
MCU Version 00.00.29
Hardware Version 00.03

 

So it's only different at FPGA Version.
I think that upgrading the firmware may solve the problems, but I can't find newer firmware.

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

I have the same firmware version:

Main version 14MX002A
 FPGA Version 57.08.05
 MCU Version 00.00.29
 Hardware Version 00.03

 

Downloaded from here: http://data.nag.ru/PBI/Software/1400MX/

 

I've never seen a newer firmware version.

 

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

Thank you for the link.

I've tried that already, the value for FPGA remains the same,  47.ef.ff

The unit keeps showing in HDMS random bitrate of value 16.776Mbps on random ASI inputs while no ASI cable connected.

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

I restarted the unit, flashed the firmware again, connected the DMM-1000CU Programmer to the Remux and set

to factory defaults. Also pressed the buton on the unit for Reset (small button on the mux pcb) for at least 10 seconds.

It finaly got reset and now it shows the correct FPGA version and the unit behaves as it should.

Thank you very much for your help, Vladimir.

 

Reards,

 

Gabriel

Поделиться сообщением


Ссылка на сообщение
Поделиться на других сайтах

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Гость
Ответить в тему...

×   Вставлено в виде отформатированного текста.   Вставить в виде обычного текста

  Разрешено не более 75 смайлов.

×   Ваша ссылка была автоматически встроена.   Отобразить как ссылку

×   Ваш предыдущий контент был восстановлен.   Очистить редактор

×   Вы не можете вставить изображения напрямую. Загрузите или вставьте изображения по ссылке.