Восстановление убитого DLINK 620 a

[cskkl64]

Есть роутер Dlink620 ревизия А (в кол-ве 40шт) пробую восстановить (делаю по инструкции от сюда: http://www.gsmforum.ru/threads/181018-%D0%92%D0%BE%D1%81%D1%81%D1%82%D0%B0%D0%BD%D0%BE%D0%B2%D0%BB%D0%B5%D0%BD%D0%B8%D0%B5-%D1%80%D0%BE%D1%83%D1%82%D0%B5%D1%80%D0%B0-DLink-DIR-620-%D0%BF%D0%BE%D1%81%D0%BB%D0%B5-%D0%BD%D0%B5%D1%83%D0%B4%D0%B0%D1%87%D0%BD%D0%BE%D0%B9-%D0%BF%D1%80%D0%BE%D1%88%D0%B8%D0%B2%D0%BA%D0%B8)

в Potto выдает:

U-Boot 1.1.3 (Feb 9 2010 - 10:44:20)

 

Board: Ralink APSoC DRAM: 32 MB

relocate_code Pointer at: 81fb0000

flash_protect ON: from 0xBF000000 to 0xBF01D3F3

flash_protect ON: from 0xBF030000 to 0xBF030FFF

*** Warning - bad CRC, using default environment

 

============================================

Ralink UBoot Version: 3.3

--------------------------------------------

ASIC 3052_MP2 (Port5<->None)

DRAM component: 128 Mbits SDR

DRAM bus: 32 bit

Total memory: 32 MBytes

Flash component: NOR Flash

Date:Feb 9 2010 Time:10:44:20

============================================

icache: sets:256, ways:4, linesz:32 ,total:32768

dcache: sets:128, ways:4, linesz:32 ,total:16384

 

##### The CPU freq = 384 MHZ ####

 

SDRAM bus set to 32 bit

SDRAM size =32 Mbytes

 

Please choose the operation:

1: Load system code to SDRAM via TFTP.

2: Load system code then write to Flash via TFTP.

3: Boot system code via Flash (default).

4: Entr boot command line interface.

9: Load Boot Loader code then write to Flash via TFTP. 0

 

3: System Boot system code via Flash.

## Booting image at bf050000 ...

Image Name: SNR-CPE-W4n

Created: 2012-08-10 15:41:05 UTC

Image Type: MIPS Linux Kernel Image (lzma compressed)

Data Size: 3532996 Bytes = 3.4 MB

Load Address: 80000000

Entry Point: 80220000

Verifying Checksum ... Bad Data CRC

 

нажать 2 не получается не принимает команду

 

Посоветуйте как оживить ???

[Ivan_83]

На живом проверьте, может у вас подключение не правильное или кабель кривой.